The inline centrifugal pumps are a core area in our manufacturing program. The inline design generates a number of advantages when it is used in larger systems, since the pumps require little floor space due to the vertical design. Therefore the plants can be constructed very compact. The pumps can be optimized for each application, under certain circumstances, by using a newly calculated hydraulic in the impeller. The casing design pressure of 40 bar allows the use in very high-quality petrochemical plants and offshore engineering. The use of simple cast iron up to high corrosion resistant special materials allows a wide range of applications for the pumps. Another focus of this series are versions that match the current API 610-OH3, OH4 or OH5. Due to the modular casing design, it is possible to vary the connections of the pump. The elevation will then not be equal anymore. Even the arrangement of the suction and discharge connection on the same side is possible.

The chemical standard pump series CNP is currently under construction and the newest addition to our program for the industrial applications. The pumps comply with the main dimensions and nominal perfomance data to EN 22858. The pumps can be optimized for each application, under certain circumstances, by using a newly calculated hydraulic in the impeller. The casing design pressure of 16 bar allows use in many areas of industry and petrochemical industries, as well as in general industry. The use of simple cast iron up to high corrosion resistant special materials allows a wide range of applications for the pumps. Another focus of this series are versions that match the current API 610-OH1.

The process pumps series CPP with centerline feet is completing the program of horizontal single stage pumps for industrial applications. The foot Arrangement allows higher nozzle loads and can accept thermal stresses. The pump can be optimized for each application, under certain circumstances, by using a newly calculated hydraulic in the impeller. The casing design pressure of 40 bar allows the use in very high-quality petrochemical plants and offshore engineering. The use of simple cast iron up to high corrosion resistant special materials allows a wide range of applications for the pumps. Another focus of this series are versions that match the current API 610-OH2.

Vertical sump pumps series ETP are single or multistage, centrifugal pumps for vertical tank installation. The guide bearings in the column pipe are generally made of silicon carbide, so that a good alignment of the shaft is achieved. This reduces vibration and leads to an increased service times. The Silicon carbide bushings are mounted elastically so that heating up will not cause high forces and cracking of the ceramic. The lubrication of the sliding bearing is usually done by the medium. There are versions available with integrated and separate discharge pipe. The sole plates as well as the installation length can be adapted to customer requirements. Main application of the sump pumps is the conveying of clean liquids from vessels and tanks. The shaft area at the sole plate can be equipped with a wide variety of seal options, so that the pumps can be mounted in pressurized tanks. The pumps are also available as a double casing versions VS6 and can thus be used for systems with low NPSH values. Based on the available material variants the conveying of various aggressive liquids in the chemical industry and petrochemical sector is possible. Another focus of this series are versions that match the current API 610-VS1, VS4 or VS6 .

The multi stage pumps series SKP has been developed further. In the meantime there are four basic sizes with different impeller versions available. Other sizes are in preparation. The pumps are depending on execution, available for different pressure ranges. For versions with double-sided ball bearing and 2 high pressure mechnaical seals system pressures up to 100 bar are possible. This enables the use in special osmosis plants or the petrochemical and offshore engineering. The pump can be optimized for each application, often by using different types of impellers in order to achieve a given characteristic requirements. The use of simple cast iron up to high corrosion resistant special materials allows a wide range of applications for the pumps. Another focus of this series are versions that match the current API 610-BB4 . As a special feature we offer the BB4 version also in a vertical version .